Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Edit volume on one section of a channel from a stereo recording
#1
Shocked 
How can I increase or decrease volume for a channel in a stereo wav file, i.e. the left channel (or a portion in time)?

I was expecting it to be as simple as selection mode - single channel... then, "selecting the range with a finger, then go to something like effects, decrease volume. As this is not the path, I've tried it with automation:

First, split into two mono tracks (ok, I thought I was walking the right path)
Then: To try to mute (as an example test) the left channel, I've selected the track 2, then press auto, then add two points at the bottom of the track (one at the start of it and the other at the end).

(please take a look at the attached thumbnail; the signal is very weak but it's there...)
   
Then, if I press play I'm still hearing the two channels... But I was expecting to hear only one Huh

I've tried also to mixdown to a wav file (see it attached), but the results are the same:
.zip   mixdown.zip (Size: 383.67 KB / Downloads: 1)

Thanks in advance !
Reply


Messages In This Thread
Edit volume on one section of a channel from a stereo recording - by obsyman - 06-18-2020, 06:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)