Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need display of stored Toneboosters filter parameters
#1
I use the Toneboosters parametric EQ. The only display of the entered parameters like Q and gain for each of the 6 filters seems to be the main EQ graphic display, which only shows a rounded off value. For example, like Q = 0.73 on the display, instead of the full entered value which was 0.725. Careful listening shows there is a sonic difference between these two values, 0.730 (display) and 0.725 (entered).

Is there any way of pulling up for display the actual values stored for the EQ filter parameters?
Reply


Messages In This Thread
Need display of stored Toneboosters filter parameters - by ambref - 06-29-2021, 03:58 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)